5 under sections 10 items found Pages: 12345678910
Hinge modulo slop controller with black cover
FN37613
Kit of 2 modulo-hinge slope controllers with black cover.
First slope regulator accepting slope lifts 6 to 17% with fixings of hinges (top and bottom lined with
45 mm (1''3/4) of the frame) inside the pillars and respecting the 25mm (1'') clearance between the gate and the pillar.
Its control system is a very
simple and avoids any slope error due to marked holes (see diagram and table depending on the choice of the slope). Fixing by 2 screws M8
(50mm (2'') interaxis adjustment of +/- 5 mm (3/16'') ensures a perfect fit on the gate.
This slope compensating model allows you to keep, as with
the modulo-hinge, all settings for the proper positioning of the gate, namely: Height adjustment 10mm (13/32''), 15mm (19/32'') plumb setting, classic setting of 20mm (3/4'').
These articulations
have anti slide serrations. Each slope regulator (high and low) based on an ear to avoid sagging of the gate as frequently encountered on this kind
of product, and also benefits from an anti unhinging of the gate.
Simplified installation of the hinges on the pillar:
Aligning the top and bottom
hinges on the pillar
2 screws spacing 50 mm (2'') for enhanced held
Positioning hinges 45mm (1''3/4) to the gate (whatever the desired slope)
Black
composite cover masking the adjusting screw.
Installation of the controller on the gate:
Same installation on pillar, but positioned 20mm (3/4'') from the edge of
the gate (to respect the space of anti pinch 25mm (1''>) and adaptable to the type of gate (whatever the desired slope)
Warning: maximum weight 70kg sash.
The gate must have reinforced mounting points
Note: For a complete gate you need two lots of two modulo hinge.
This article is sold individually
or has a volume discount. This is held in permanent stock