First slope regulator accepting slope lifts 6 to 17% with fixings of hinges (top and bottom lined with 45 mm (1''3/4) of the frame) inside the pillars and respecting the 25mm (1'') clearance between the gate and the pillar.

Its control system is very simple and avoids any slope error due to marked holes (see diagram and table depending on the choice of the slope). Fixing by 2 screws M8 (50mm (2'') interaxis adjustment of +/- 5 mm (3/16'') ensures a perfect fit on the gate.

This slope compensating model allows you to keep, as with the modulo-hinge, all settings for the proper positioning of the gate, namely: Height adjustment 10mm (13/32''), 15mm (19/32'') plumb setting, classic setting of 20mm (3/4'').

These articulations have anti slide serrations. Each slope regulator (high and low) based on an ear to avoid sagging of the gate as frequently encountered on this kind of product, and also benefits from an anti unhinging of the gate.

Simplified installation of the hinges on the pillar:

• Aligning the top and bottom hinges on the pillar
• 2 screws spacing 50 mm (2'') for enhanced held
• Positioning hinges 45mm (1''3/4) to the gate (whatever the desired slope)
• White composite cover masking the adjusting screw.

• Same installation on pillar, but positioned 20mm (3/4'') from the edge of the gate (to respect the space of anti pinch 25mm (1''>) and adaptable to the type of gate (whatever the desired slope)
• Warning: maximum weight 70kg sash. The gate must have reinforced mounting points

This article is sold individually or has a volume discount.
This is held in permanent stock


[FN37612]  Detail